algorithmic modeling for Rhino
unequal reparametrized surface subdivision
Dear all,
I'm new in gh scripting and i found it very useful.
But.... I have a problem:
I made a script that:
1) create a curve
2) extrude the curve
3) subdivide a curve
even if i reparametrize the extruded surface (nothing of complicated it is a slice of cilinder..) the subdivision is not costant.
If I draw the same surface with rhino and then i set it in the script, all work fine.
Have you any suggestion?
Views: 652
- Attachments:
-
-
subsurface.gh, 43 KB
-
Replies to This Discussion
-
Permalink Reply by bertzm on
-
at the moment I found a solution by rebuilding the surface, but i'm sure there is a more elegant solution
-
-
Permalink Reply by David Merlin on
-
Marco,
When you say constant subdivision, I'm assuming you are trying to get equal lengths? How a surface is subdivided depends on the surface domain. There have been a number of good discussions about this on the forum. Here's one of them:
http://www.grasshopper3d.com/forum/topics/unevenly-divided-surface?...
Other resources you can check out are on the tutorials page like Essential Mathematics.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
