Grasshopper

algorithmic modeling for Rhino

Unable to connect two wires into one 'slot' on a node

I can't get to wires to connect into the same slot of a Loft node to loft curves, or in fact connect two wires into the same slot in general. (I tried plugging both curves into a curve collection then that to the Loft node, but they wouldn't plug into that either).

Tutorials etc take for granted that this is possible. I'd be grateful if anyone could help me out?

Link and image below.

Hexagons.gh

Views: 7181

Replies to This Discussion

Hello

you can connect multiple wires when you press and hold shift  during connection. you will get a small + sign when trying to connect. (for the second third etc wire)

Thank you so much!

Plug one and use shift to plug the next, hope this helps

Attachments:

Thanks very much!

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service