Grasshopper

algorithmic modeling for Rhino

Twist happened when use sweep1

Hi guys,

I want to make nurbs from points, using sweep. But the twist happened.

Why did that happen? And How to solve that?

Thanks.

Views: 879

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 11, 2016 at 10:44pm

Whenever twist problem happens, you could suspect the directions of your section curves and mismatching seam positions. Check attached. Best.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service