Grasshopper

algorithmic modeling for Rhino

Hi! thank you in advance, I'm trying to pull the curve,generated in anemone, to tie it around the cylinder, but I can't succeed to only tie it around and don't let it to go inside the cylinder.
More over, I'd like to know if there's another way in Kangaroo to tie a curve around an object, like a rope that is pulled on one end. Thank youu!

Views: 965

Attachments:

Replies to This Discussion

Can upload file only with geometry for kangaroo without boid library?

If you only want to "project" the curve, you can use "Pull Point".

If you still want to use kangaroo, i think you need to anchor one extreme and then use the mouse to grab (alt key) the other extreme and manually pull. Also set the segments lines with original length and points OnMesh.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2021   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service