Grasshopper

algorithmic modeling for Rhino

Trouble with "curve on surface" on a lofted surface

My first Grasshopper is killing me.

I have this this surface I have lofted through multipel curves. On this surface I want to make a diagrid structure with "curve on surface".  But the loft compoment wont work with my diagrid compoments, because if I bake the loft compoment into rhino and apply the diagrid compoments to the baked surface, it then works.

 

What am i doing wrong.

 

 

Views: 2012

Attachments:

Replies to This Discussion

Permalink Reply by simon.mouritsen on January 15, 2011 at 11:05am
No ideas?
Permalink Reply by Chris Tietjen on January 15, 2011 at 4:50pm

Have you tried getting your dia-grid pattern working on a simpler surface?

Chris

Permalink Reply by Chris Tietjen on January 16, 2011 at 8:48am

Perhaps there's something helpful in this.

 

Chris

Attachments:
Permalink Reply by simon.mouritsen on January 16, 2011 at 10:08am

Thanks it still not working. And I have tried to merge the two documents without any luck.

 

I was wonering if its because it's a untrimmmed surface?

If I Bake the geometry to rhino and apply the "diagrid on surface"-difinition to the surface (a brep surface), it then works.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service