Grasshopper

algorithmic modeling for Rhino

trim geometry leftover

Hello,

 

I have a series of boxes along a curve that I am trimming on either side with surfaces. It works just fine, however the old geometry is still there overlapping the new. You can see the trimmed boxes(green) in the image and the old(red) overlapping. Is there a way to have it only show the new geometry? Thanks.

 

Views: 548

Replies to This Discussion

Permalink Reply by Danny Boyes on March 22, 2011 at 4:59pm
If you right click on a single component you can turn off the preview. If you want to turn of lots of components at once then you can use the toolbar option, the blindfolded head.
Permalink Reply by Philip Vriend on March 22, 2011 at 5:36pm
Thanks, I was sure I did that already, but now when you suggest it, it works.
Permalink Reply by Danny Boyes on March 22, 2011 at 5:37pm
it's always the way, sod's law

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service