Grasshopper

algorithmic modeling for Rhino

topography trouble

Hello,

I am working on a topography right now. I have generated curves into rhino from a dwg survey that I have. The topography intervals are 5 foot each and I need to create 2.5 foot intervals. I could not find any way of creating a semi accurate curve for this. I was hoping that there is some command where I could offset two selected curves and make a hybrid that could follow in between two 5 foot interval lines. Any help is appreciated. Thank you.

Views: 356

Replies to This Discussion

Permalink Reply by djordje on January 7, 2013 at 12:09pm

Try using "Tween curves" Rhino command, if you are working in Rhino 5.

If you are still working in Rhino 4, check this:

http://www.grasshopper3d.com/xn/detail/2985220:Comment:764926

Permalink Reply by Alex on January 7, 2013 at 12:13pm

tween curves worked! Thank you Djordje!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service