Grasshopper

algorithmic modeling for Rhino

TinyG + Firefly

hi, 

i'm am running some tests on stepper control from tinyG v8 via Firefly. Sending data via the 'generic serial write' works great but can't seem to read the controller(<empty>). Anybody thoughts?

Views: 478

Replies to This Discussion

Permalink Reply by CS Bowen on June 1, 2015 at 12:34pm

hey peter

did you ever figure out a solution to this problem?  i am having the same issues with the serial read returning an <empty> value.

any advice would be very helpful!!

thanks

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service