Grasshopper

algorithmic modeling for Rhino

TDM solutions and nesting question

Hi everyone, 

I've got a question that i haven't been able to to figure out.

I've got a series of Breps (sections of a surface), that I am trying to layout onto a sheet. 
The problem is, when i try to translate them to the z plane, all the Breps are layered over top one another.

It's as if i'm missing a step where i indicate that the operation should be performed to all the Breps individually and not as a single shape.

I hope that makes sense. 


Any input appreciated,


Thanks,

 

Carlos 

Views: 760

Replies to This Discussion

Permalink Reply by kleerkoat on February 7, 2011 at 11:01am

I'd head over to the RhinoNEST forums for this question.  I haven't tried what you are doing but you'll probably get a quicker response.

 

http://www.rhinonest.com/forum

 

hth,

ryan

Permalink Reply by carlos mauricio rodriguez on February 7, 2011 at 11:02am

Good call-

Thanks!

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service