algorithmic modeling for Rhino
Taper Pipe Command??
I've been musing over this for a while...
Is there an efficient way of piping the outer poles of my model so that the bottom diameter is larger and each tapers towards a smaller diameter at the top?
This is a standard function in Rhino, but the pipe command in GH doesn't allow for this in the same way, and i can't seem to find an 'easy' work-around in GH.
It may come to me in my sleep, but any ideas are more than welcome!
Thanks,
Is there an efficient way of piping the outer poles of my model so that the bottom diameter is larger and each tapers towards a smaller diameter at the top?
This is a standard function in Rhino, but the pipe command in GH doesn't allow for this in the same way, and i can't seem to find an 'easy' work-around in GH.
It may come to me in my sleep, but any ideas are more than welcome!
Thanks,
Views: 1060
- Attachments:
-
-
GH Tower 01.jpg, 715 KB
-
Replies to This Discussion
-
Permalink Reply by Yann on
-
Hi David,
Why don't you create perpendicular frames all along your curves. use them to localise circles with a radius generated with a serie component, and then loft generated circles? -
-
Permalink Reply by David Wood on
-
Hi Yann,
Thanks for the suggestion. My work around with the loft was pretty long-winded, i'll try using the series component though. Thanks. -
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Tensile Column
Added by Parametric House 0 Comments 0 Likes
-
Circle Packs
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
