Grasshopper

algorithmic modeling for Rhino

Tangent Arc to curves

Hi All, 

 

I started using VB Script Component in my grasshopper code, I am searching for a way to call the rhino commands in the script. It would be really helpfull if some one can help me on this.

 

I am looking to call the following curve

Arc, which is tangent to 2 curves and starts from the first point of the first curve 

 

Thanku :)

 

Views: 915

Replies to This Discussion

Permalink Reply by David Rutten on January 31, 2011 at 2:36am

Hi Sudhir,

 

this will be exceedingly difficult, if not impossible. You can run Rhino Commands from within a VB component, but the Arc Tangent command option requires you to pick points on other curves which is very tricky to automate. 

 

If your input curves are simple, there might be an analytic solution to your problem, but otherwise I'm out of ideas.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service