Grasshopper

algorithmic modeling for Rhino

Sweep 2 Rails not working as expected

Hello everyone,

I am having trouble with the sweep 2 rails command. I am trying to sweep curve 1 across curves 2 and 3. 

Curve nr 3 was at some point split and rebuilt. I couldn't get the sweep command to work, so I did the same operation on curve nr 2, hoping to get it to be defined in the same way as curve nr 3. The sweep command still didn't work. I then tried reparametrizing and flipping the curves (brainlessly, by trial and error), and still no combination worked.

Baking the curves in Rhino and trying the sweep 2 command there produced the same wild results.

Any ideas?

Views: 2273

Attachments:

Replies to This Discussion

Permalink Reply by MihaiB on May 26, 2016 at 6:41am

Hello Tom

Thanks for the quick reply.

I realised that I obtained curve 3 by projecting curve 2 on a very dense network surface, so that's where the control points come from.

I got the sweep to work by rebuilding curve3 and then breaking the rails into two parts.

Thanks for the advice!

Permalink Reply by Hyungsoo Kim on May 26, 2016 at 6:30am

Hi.

You can do it in the following manner by using GH  Best.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service