Grasshopper

algorithmic modeling for Rhino

Surface UV Division

Hi-

I'm trying to divide a surface with a Density Control approach. Below is what I'm trying to do. I've also attached my grasshopper file. However, the surface in the GH file is a surface genertad from a revolving curve rather than a flat surface but I presume it will be the same appraoch. any help is greatly appreciated.

Views: 2987

Attachments:

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Marios Tsiliakos on January 19, 2014 at 12:12pm

there you go,

Hopefully its clear enough.

best,

M.

Permalink Reply by Hessam Kazemzadeh on January 19, 2014 at 1:08pm

Thanks, Marios

Are you using another plug-in here? doesn't seem to be normal GH command boxes.

Permalink Reply by djordje on January 19, 2014 at 1:20pm

No, all standard grasshopper components.
The green ones you will find in Math->Domain. Orange palm is "Explode tree". The one with torsion of two ropes is "Entwine".

Permalink Reply by Marios Tsiliakos on January 19, 2014 at 1:55pm

I think my friend Djorgje just answered pretty much everything.

Best,

M.

Permalink Reply by Hessam Kazemzadeh on January 19, 2014 at 1:58pm

thanks everybody. I'm new so apology if i ask preliminary questions.

Best,

Hessam

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service