Struggled visualize the surface results

Hi every one, 

I have finished my first energy simulation using the Honeybee, Finally, I could run the simulation, and I have used the "color zones by EP results" successfully, but when it came to the surface results visualizing and making "indoor radiant temp map" I stick !!

the thing is, I hooked up the "srfsData" and "HB zones" to the "color surface by EP results" and it went good ,so, I used the same parameters to run the "surface data based on type" but it showed an error, 

In addition, the "indoor view factor was OK but when I use it to generate the "indoor radiant temp map" it also showed an error as attached below.

I am a very bigger with the data tree structures,so I tried disparately to trail and error by grafting and flatten lists, in some instances, errors turned into orange instead of red ! 

I hope someone can guide me through this..