Stepped Topography

Hi! I'm having some problems to create a stepped topography. I'm not trying to make a surface with topography lines, I want to create a surface with each boundary, extrude them and then move the extruded surfaces along vector z. The problem is that I only have the flattened lines so I need to create a code that allows me to move up each curve away from each other by 2 units.This is what I'm trying to make...

I've done this by moving curves in rhino before setting the curves in grasshopper...

Can someone help me? I just started to explore grasshopper... Thanks!

Replies to This Discussion

Permalink Reply by peter fotiadis on November 24, 2015 at 12:00am

That's rather easy: post your curves and have faith.

BTW: Since they are all flat the challenging (not nuclear science ... but still) part is to create some rules for the extrusions (which is the "lower", which follows etc etc). If they were all closed that could be rather elementary ... but I bet that they are not.

RSS