algorithmic modeling for Rhino
Split different surfaces into subsurfaces with equal dimensions.
I am building cover for the metro entrance and I'm stuck in one moment.
I want to divide each wall of the cover into segments with equal width.
Side walls and roof were divided and I want to divide the back wall into subsurfaces with equal width. It would be also great if the panels would be measured starting from back wall's center vertical axis.
Views: 1737
Replies to This Discussion
-
Permalink Reply by Chris Tietjen on
-
It was faster for me to create my own definition, but maybe this will give you some ideas. If your panels are all going to be the same width then you have to accommodate for this in the sizing of the base. This definition only gets them pretty close between the side and back walls...perhaps though visually sufficient.
Chris
- Attachments:
-
-
MetroEntrance.ghx, 399 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
