Grasshopper

algorithmic modeling for Rhino

Split Curve with Brep Point Problem

Hi, I am trying to do something that I think should be very basic, but isn't working.

I am trying to split a curve with a singe BREP and extract the split points. However, while my curve intersects the BREP multiple times only one split point is output even though more than two curves are output. 

Does anyone know why this is happening and how I can get all the points to output?

Thanks

Views: 1582

Attachments:

Replies to This Discussion

Permalink Reply by Jonah Hawk on May 16, 2012 at 9:53pm

Use Split with BrepS ;-)

Permalink Reply by David Rutten on May 17, 2012 at 3:31am

But if it's only one Curve and one Brep, it should have worked with the singular.

In fact I can get all those points using the original component.

Paul, can you post the files I need to reproduce your bug?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by paul on May 17, 2012 at 11:15am

David, Here are the files that are giving me the bug

Thanks

Attachments:
Permalink Reply by David Rutten on May 21, 2012 at 3:39pm

Hi paul,

those files run fine on my internal version (0.9.0001). Perhaps the bug has already been inadvertently fixed. Let's see if it still fails for you once 0.9 is released.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service