algorithmic modeling for Rhino
Spherical Walls
I'm trying to control portions of the sphere that I want to become a wall. I can't figure out how to trim the sides of the sphere. I can get the top horizontal plane to intersect the sphere, but not the vertical planes. Any ideas on how to accomplish this?
Views: 190
- Attachments:
-
-
Sphere.jpg, 612 KB -
Concentric arcs.zip, 1.3 MB -
extractisocurve.ghx, 279 KB
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Ngon Mesh
Added by Parametric House 1 Comment 0 Likes
-
Minimal Surface
Added by Parametric House 0 Comments 0 Likes
-
Wind Pavilion
Added by Parametric House 0 Comments 0 Likes
© 2026 Created by Scott Davidson.
Powered by
