Grasshopper

algorithmic modeling for Rhino

Hi Guys,

I am trying to create a diagrid pattern in a surface using LunchBox Diagrid Structure and wanted to get a random sub-division as shown in the attached example [Sheffield University] with control over filleting the ends.

Would it be possible to get control over the width [as shown in sketch] of the diagrid as well

Any help would be appreciated.

 

Thank you in advance

Views: 5925

Attachments:

Replies to This Discussion

Not exactly what you want but it can help you

 

Attachments:

That is really helpful Felipe. Thank you very much. Appreciate you help

Like for like! : http://www.sheffield.ac.uk/efm/currentprojects/thediamond/architect

Thanks Felipe, think so far you are the only netizen posting the grasshopper definition and especially with the level of control it gives. I hope I can take it further e.g. control by curves or solar mapping as a shading device.

Thank you for this solution, Felipe.
I am just wondering and struggling to figure out which component you used as the picture shown.

Its been a long time. So if you have idea or advice, I really appreciate that.

Hiroto

yes, very helpful thank you!

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service