Grasshopper

algorithmic modeling for Rhino

Slider and Endpoint problem

Hi Everyone,

I am working on a floor plate system, I have added an additional endpoint/corner along the y-axis. The Floor plates Cantilever by increments, controlled by a slider.

When I turn the "Cantilever floor increment" slider on, the endpoints seem to collapse. Is there a way that I can add the additional endpoint on the Y-axis without altering the "Cantilever floor increment" slider? Thanks

Views: 402

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on December 15, 2014 at 7:37pm

I've just clean up your def. and it seems work anyway.

You can change plan shape using < Lower part Y position (center)>slider

Attachments:

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service