Grasshopper

algorithmic modeling for Rhino

Simplify control points on polyline

hi,

is there a known possibility to keep among the curve control points only those defining the sides of the polygon and erase all the rest and remain desired degree to 1. In my case knots are only the corners.

thank you

Views: 1662

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 9, 2017 at 3:34am

How about to use "Simplify Curve" component?(Curve--> Util---> Simplify Curve)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service