Grasshopper

algorithmic modeling for Rhino

Hello,

The attached simple sweep1 is not working, however it is working if done manually in rhino.

Any help would be appreciated.

Hava

Views: 2385

Attachments:

Replies to This Discussion

Thanks I-G,

That solves my current problem, however I am curious concerning the sweep1 problem, any clue about the reason?

Hava

Sorry! I do not know about this in Grasshpper, but it is made possible by Rhino

You can successfully do a sweep1 on a closed rail curve if you put a small break in it.  The two end curves of the sweep have the same direction when viewed from the outside (in this case clockwise) but when viewed along the direction of travel around the rail they end up opposing each other when they meet.  This may be why the sweep fails but I'm not sure.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service