"Shatter" a curve and cut extra segments

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 23, 2017 at 11:34pm

Why don't you use "Map to Surface"  together with "Pull Curve"?

Attachments:

• RF_shatter_Re.gh, 17 KB

Permalink Reply by Francesca Burchi on February 24, 2017 at 1:29am

Actually this doesn't solve the problem because I still don't have the intersection points. I need the curves to ends at the blu X and to cut off the red parts.
And it has to work also on a double curved surface

Permalink Reply by Hyungsoo Kim on February 24, 2017 at 2:57am

If so, why did you use "Reciprocal" component from the first place?

If you had thought a little bit more, then there would have been a better way to choose ...

Permalink Reply by Hyungsoo Kim on February 24, 2017 at 3:08am

File..

Attachments:

• RF_shatter_ReV2.gh, 22 KB

Permalink Reply by Hyungsoo Kim on February 24, 2017 at 3:23am

If you rebuild the final polyline curves, you don't have to use "Pull curve".

Attachments:

• RF_shatter_ReV3.gh, 21 KB

Permalink Reply by Francesca Burchi on February 24, 2017 at 7:17am

Thanks!!!

Permalink Reply by 0ddw589ypu3jv on February 24, 2017 at 4:36am

Hi,

You can do as follows:

Attachments:

• RF_shatter(Panda).gh, 25 KB