SetPoints in Grasshopper?

Replies to This Discussion

Permalink Reply by David Rutten on July 25, 2012 at 5:05pm

Hi Daniele,

you can use the [Project] component in the Transform tab to project any geometry (including points) onto any plane. Or you can use the [Plane CP] component which will only work on points and planes. Or you can use the [Decompose] and [Point XYZ] components in succession and not transfer one of the components which is most akin to SetPt functionality.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Daniele Profeta on July 25, 2012 at 5:22pm

Thanks a lot David.

I realize it wasn't that much of a smart question.

Thanks again!

Daniele