Grasshopper

algorithmic modeling for Rhino

Serpentine pavilion 2002 recreation problem

Hi guys,

I am a complete newbie to grasshopper and rhino and may have bitten off more than i can crew. I have tried to recreate the serpentine pavilion from 2002 in grasshopper (file attached) but I'm not sure what I have done wrong for it not to work?

Any expert that wouldn't mind looking over my work would be greatly appreciated. 

http://www.lepenseur.it/aad_book/chapter_07_01.jpg large scale of image i followed. 

Views: 1392

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on December 28, 2014 at 5:27am

I don't have hoopsnake installed here, but do you really need it? I think you can generate angles and scaling factors using Series components:

Attachments:
Permalink Reply by Simon on December 28, 2014 at 6:05am

Thanks david that is hugely helpful. Greatly appreciated and so quick.

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service