Grasshopper

algorithmic modeling for Rhino

Selective Fillet

I am trying to perform a selective fillet (on a few but not all corners) of a polygon rather than the global fillet of all curves that seems to be available on the toolbar. Any help?

Views: 433

Replies to This Discussion

Permalink Reply by Theunis du Toit on November 18, 2009 at 10:36am
Explode the curve, then list individual curves, join them again to offset them. Does that work for you?
Permalink Reply by Theunis du Toit on November 18, 2009 at 10:36am
Image
Attachments:
Permalink Reply by Jonathan M on November 18, 2009 at 10:58am
I think that will work. Thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service