Grasshopper

algorithmic modeling for Rhino

Selecting Geometry from rhino

Hi,

I have had this for quite some time - sometimes, when I right click on a comonent in the gh window to select geometry to be assigned / input to a component, either 1 or multiple, in the rhino window i get prompted to actually draw the line / click for a point, etc. rather than selecting geometry that exist already....

Seems to be a bit unpredictable ... but didn't used to be like this

any ideas ?

Thanks,

Peter

Views: 2178

Replies to This Discussion

Permalink Reply by David Rutten on November 6, 2014 at 1:33pm

If there's a point to select, the Point parameter will default to Object, if there's no point object available it will default to Coordinate. If there's a pre-existing point loaded the default will depend on what type it is.

Lines do not support referenced geometry, so that will always ask you to draw one. If you want to import rhino line curves, you'll need to use the curve parameter.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service