Grasshopper

algorithmic modeling for Rhino

scaling question

hi everyone,

 

i am stuck with a scaling problem. what i wonna do is create  a bunch of circles along the division points of a curve-then scale those circles up/down and both of it at the same time (like a hyperbolid)... i can do up or down-scaling with the scale comp and a domain... but up from start to midpoint and down from midpoint to end is only possible if i use 2 cull comps... (pic)...

 

does anybody know how to do this in one step/with one operation?

 

would be very thankful,

w

Views: 247

Attachments:

Replies to This Discussion

Permalink Reply by morteza farhadian dehkordi on March 5, 2011 at 10:06am
see
Attachments:
Permalink Reply by weltraum on March 5, 2011 at 10:14am

ok, thx a lot. looks little advanced :)

good to know - i ll check it out !

 

w

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service