Grasshopper

algorithmic modeling for Rhino

rotate/align CPlane on surface to "orthogonal"

Hi there,

Could anyone advice me how I could rotate CPlane to orthogonal position? They are all rotated on the surface...

see screenshot below:

what I want to achieve:

Uploaded the problem surface, hope someone could kindly advise how this could be tackled. Thanks a lot!

Views: 1075

Attachments:

Replies to This Discussion

Permalink Reply by Mateusz Zwierzycki on May 11, 2012 at 8:45pm
Permalink Reply by Jeffrey on May 19, 2012 at 1:51am

Thanks for your reply.

I did spend a week trying to correct it but still having no luck...: (

Could you give me a more specific instruction of how it could be done?

Thanks again!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service