Repeating top floor facade to floors below, reducing facade element progressively by one?

Hi,

I drew the top floor of a facade, and now I would like to have the same on the floors below, but with the vertical fins to decrease with each floor by one. This way I would need only one slider to control the whole thing.

The vertical fins need to be more densely packed towards the right, as it's shown on the top floor.

To the fins there are attached also the glazed/opaque facade panels which are already set to be proportional and linked to the same points along the horizontal as the vertical fins.

I need to have one slider controlling the number of vertical fins and one controlling the proportion of glazed/opaque.

Therefore, I ideally need to keep the floor as I already drew it and "just" find the way to have it at all floors as described above.

I need to do it with the Series Component, but after days of attempts I am not succeeding. I just learned a bit of Grasshopper, can anyone help please?

Hoping for a possibly fast feedback, many thanks in advance.