Grasshopper

algorithmic modeling for Rhino

remap/reverse attractor point

I know this question was asked here about a million times, yet I still can't seem to make it happen. I need to simply reverse an attractor point's effect, so it will pull my geometry instead of "squeezing" it. Just the opposite of what is seen in the picture. any help?

Views: 632

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on November 15, 2015 at 5:09am

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service