Region Union with not planar regions?

Hello all, I have a set of breps that intersect each other, and I would like to join them and just keep the outer curve, as shown yellow in the image. But no luck so far with brep join. Any ideas?

Thank you,

Shynn

Attachments:

Join Breps.gh, 54 KB

Replies to This Discussion

Permalink Reply by iro skouloudi on October 12, 2017 at 3:27am

Hello! I've tried to extract the wireframe in one set of your breps using intersection solver between them. It worked in the case of 2 breps. I had an issue in the case of more than 2 breps intersecting. I think it's all about managing your lists. I hope I've helped you in a way!!

Attachments:

WIRES.gh, 54 KB

Permalink Reply by ShynnSup on October 12, 2017 at 8:45am

Hello, thanks for your reply. Unfortunately, I was already able to join 2 breps and then keep only the outer edges with the brep edges component, the problem still are the regions that have more than 2 breps.

Permalink Reply by ShynnSup on October 14, 2017 at 5:15pm

Any ideas?

Permalink Reply by iro skouloudi on October 15, 2017 at 2:40am

well, I tried this..it worked in one case but I think it's too coplicated to use it in a list. I think the problem is that the curves are not planar to use region components or merge faces component.

Attachments: