Re-Roll Mesh after Running "Unroll Brep"

Does anyone have an input on this_?

I unroll a brep/mesh....I am no projecting a series of generated curves and I want to re-roll the surfaces back into the original shape WITH the project curves.

I know that I can just project the curves to the brep/mesh while it is still a volume but I am not liking the translation of the projected curves doing it that way.

Is there a way to right a definition that can re-roll it self in that way_?

thanks, Gustavo_

Replies to This Discussion

Permalink Reply by Jack Young on August 27, 2016 at 8:03am

If you figured this out would love to know. I have a complex louvre system I want to rewrap my building in :)

Permalink Reply by Jack Young on August 28, 2016 at 9:37am

Hey I ended up having to recreate the divisions on my curved surface and then oriented the individual geometry I had created onto this. Took a bit of fiddling but it turned out pretty well. Hope this helps