Grasshopper

algorithmic modeling for Rhino

Radius of arc

 Is there a component that retrieves a radius just from a simple arc or curve?

Thanks

Vern

Views: 2518

Replies to This Discussion

Permalink Reply by Danny Boyes on March 22, 2012 at 8:22am

The Centre Component will give both a Centre Point and a Radius on all Arcs and Circles. If you want to check a curve then you can analyse the Curvature at given t parameters. Both Components are located in Curve Tab > Analysis Panel.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service