algorithmic modeling for Rhino
Hello Mostafa,
I am using the Radiation analysis component. The result is always 0
and I have noticed that the output of the GenCumulativeSky component,
the GenCumSkyResult is always 0 in all the items. The epw weather file and
the GenCumulativeSky.exe are working properly. Can you imagine some issue?
I attach an image of the definition. As you can see from the Panel attached to the
genCumSkyResult output all the items are 0 (up to the 25th line is visible but also
all the others are). The report output says that "There were 3 sun up hours in this climate file", is it ok? Thank you.
Best
Francesco
Tags:
Replies are closed for this discussion.
You know better Mostapha, but this happened with me twice. So now I have found a way around it by extruding the surface a little bit.
One of my classmate also had the same problem. She had an outer shell of building, which was essentially a surface, and she was trying to perform radiation analysis with it. I recommended her to make a closed solid. It worked perfectly in her case too.
Thanks,
It is good to know that extrusion solves the problem, but if it happened to you again please send me the file so I can find the cause. Thanks.
-Mostapha
Sure. I will do that.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by