Grasshopper

algorithmic modeling for Rhino

question on unroll srf and inverse

when i unroll a srf and a crv on the srf. then i get the crv on the plan srf.however,when i modefy the crv on plan srf.how can i make the crv on srf get the exact change.i wonder grasshopper can make it happen.

Views: 477

Attachments:

Replies to This Discussion

Permalink Reply by veaturn on November 3, 2017 at 3:17am
help!help!
Permalink Reply by Ethan Gross on November 3, 2017 at 3:32am

Transform-> Morph -> Map to Surface. Also, when using Map to Surface, make sure your curve has plenty of control points or else it will be too "stiff" and not map correctly to the target surface. This might require you to rebuild the curve.

Permalink Reply by Ethan Gross on November 3, 2017 at 2:07pm

I didn't notice before I wasted my time on a reply that you first asked this question two years ago  - and now you are asking for help? What's the hurry?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service