Grasshopper

algorithmic modeling for Rhino

Question from a beginner

Hi there,

I'm trying to copy a surface that is Irregular, then I need to offset the copied surface just a little bit to the inside of the surface, to create a little bit smaller surface. I exploded the surface edges, then I tried to offset them, however, because the shape is irregular I wasn't able to get clean interesting edges to create a surface from. I also tried scaling the surface down, but again it didn't work because the shape isn't a regular one. any ideas . I attached the Rhino and Grasshopper file. 

Thanks in advance.

Views: 340

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on February 7, 2015 at 4:32am

Hi.

Check attached files.

Attachments:
Permalink Reply by Ninja on February 8, 2015 at 1:44am

Hi Hyungsoo,

Thanks a lot for your help. I guess the key point is joining the curves .

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service