Grasshopper

algorithmic modeling for Rhino

Quad / Tri surface to meshface

Another potentially simple question.

I am trying to convert trimmed surfaces constructed from either 3 points or 4 points to a meshface. Then combining these meshfaces into a mesh. But somehow, because some of these quads have two colinear edges, they mess up the mesh join component.

I need the extra point to be there to ensure compatibility when simulating using Kangaroo, for example.

Thanksl

Tim

Views: 310

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 17, 2017 at 1:04am

Check this.

Attachments:
Permalink Reply by Tim Chen on August 17, 2017 at 12:49pm

Very ingenious! Thank you very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service