Grasshopper

algorithmic modeling for Rhino

Within the rhino environment, I am able to do the above.  However in the grasshopper environment, the pull curve only works with brep surfaces.

I have found a way round this however by generating points along the curve, then pulling the points onto the mesh surface.  Then I create a new curve passing through this pulled points.  Would be neater if the grasshopper pull curve component can accept mesh surfaces as target surfaces.

Views: 1393

Replies to This Discussion

Hi

Unfortunately my mesh surface is a complex 3d shape so I cannot convert it to a surface as in your example.  However, thank you for looking into it.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service