Grasshopper

algorithmic modeling for Rhino

Protrusions on a surface

Hi,

I'm having trouble creating protruding elements from a flat surface.

I've started by creating a mesh with circular holes along its surface.

The effect I am trying to achieve is one similar to the London Olympic shooting venue (see attached)magma10.jpg

I did not understand what went wrong, should I set individual anchor points inside the holes?

Any input, suggestion or other help would be much appreciated.

 

Views: 583

Attachments:

Replies to This Discussion

Permalink Reply by Marios Tsiliakos on March 31, 2013 at 3:26pm

Hi,

I didn't get a chance to look at your file but this should help you.M.

Permalink Reply by Eleni on April 4, 2013 at 9:13am

Thank you so much I' tried to replicate it but I guess I am doing something wrong. Do u mind having a look at it? If you can't it's ok. Thank you very much once again.

Attachments:
Permalink Reply by Marios Tsiliakos on April 4, 2013 at 11:03am

Unfortunately you can't use your existing mesh. Please mak sure you study the following/.

Best,

M.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service