Grasshopper

algorithmic modeling for Rhino

Problems with Voronoi Pattern

Hello,

I am trying to apply a voronoi pattern now and facing a few issues. 

Firstly I have a planar surface and I want to work with a selected offset but the pattern varies I dont understand why?

As you can see above this is sort of all over the place, which brings me to my other question. 

On scaling the surface some of the curves are missing, as seen below,

I wanted to weave the oustide edges with the offset I have created to obtaine one single surface that I can then thicken with weaverbird or just normally. I have attache the GH file and well a simple planar surface.

Any suggestions? 

Thank You so much 

Views: 778

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 25, 2017 at 3:45am

Like this?

Attachments:
Permalink Reply by Gaurav Chauhan on August 25, 2017 at 11:41am

Again, Thank You so much I am learning, amazing!

Permalink Reply by Gaurav Chauhan on August 29, 2017 at 5:54am

Hi

I got the surface that I wanted but when I apply the surface subdivision from WB I get a lot of sharp potruding edges and that really destroys the appeal. Is there a way to fix this? I have attached the surface and the GH file for your consideration. 

Thank You so much

Attachments:
Permalink Reply by Hyungsoo Kim on August 29, 2017 at 7:31am

I've already mentioned about that(defining mesh topolory) in your previous post.

Check the attachment in that post.

Permalink Reply by Gaurav Chauhan on August 30, 2017 at 1:05am

Thank You

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service