Grasshopper

algorithmic modeling for Rhino

Problem lofting an intersecting curve

Hey guys!

In my head I thought this would be really easy, but for some reason my two curves won't loft. One curve is just a circle and the other is an intersection between a circular tube and a curved surface.

Or is there an other smart way to set a cone on a curved surface? I don't want to first bake a cone and then trim because I need the bottom of the cone to be circular in plan (even though it's not flat in elevation).

Thanks!

Views: 401

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on May 7, 2012 at 3:58pm

add a graft tree component to your scale, that will make both branches the same (0,0)

see attached

best

m

Permalink Reply by Børge Raknes on May 7, 2012 at 4:13pm

Ah, that easy! :)

Thanks a lot!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service