algorithmic modeling for Rhino
Phylogenic curves
Hello, I'm new in Grasshopper, I ve been studying the auditorium park in barcelona from foa: in gh i ve managed to create a field of parallel curves, but i was wondering if there was a geometrical way to create from ellipses, not using force fields, patterns like the| attachement.
thank you!
Views: 380
- Attachments:
-
-
gh pd.gh, 11 KB -
Geometria.jpg, 104 KB -
024.BCN_Park_View01.jpg, 625 KB
-
Replies to This Discussion
-
Permalink Reply by mark zirinsky on
-
here are some of the grasshopper components for creating ellipses. The trick is to calculate the base geometry needed.
-
-
Permalink Reply by F L on
-
Thank you mark! however, I was wondering after creating the ellipse if there was a controlled way to alter the"control points" of the parallel curves like the attachement below.
- Attachments:
-
-
Captura2.PNG, 67 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
