Grasshopper

algorithmic modeling for Rhino

parametric Curve with distance controller

Dear My friends

I want to create such this curve.

I want to control distance1 and distance 2 , 3 , 4 ... with sliders.

please help me to create an algorithm.

What is the shortest algorithm?

we can create it by using Construction point but the route will be too large.

I am looking for a route to create this curve with using Range and series with domain distance controller.

(download 3dm file please)

Thank you

.

Views: 482

Attachments:

Replies to This Discussion

Permalink Reply by Petras Vestartas on August 28, 2017 at 10:29am

Upload a sketch image

Permalink Reply by tube on August 28, 2017 at 10:41am

Thank you for your reply.

I have uploaded an image.

Permalink Reply by Joseph Oster on August 28, 2017 at 1:24pm

Attachments:
Permalink Reply by tube on August 28, 2017 at 2:30pm

Dear Joseph Oster 

Thank you very much for your reply.

that was great.

but I have a question.

in rhino, we have had command named "control point curve"

you can see in my picture below :

but you are using "interpolate".

interpolate command in grasshopper will not create mirror curve!

is there any curve command in grasshopper to create mirror curve?

Please look at left and right side of curves.

Permalink Reply by Joseph Oster on August 28, 2017 at 2:06pm

Better:

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service