Paneling Tools Morph 3D List in GH

I've been using the Morph 3D List component in GH for some time and it has worked in the past. However, trying to use it lately (past few days) and it takes the entire PO list and places all of them in each grid cell? Attaching a GH file. Please advise.

Attachments:

pt_morph3dlist.gh, 12 KB

Replies to This Discussion

Permalink Reply by nikos tzar on September 19, 2014 at 9:06am

From the new PT release:

"1- Added anew component to morph variable 3D components using mean or tween method between matching curves, meshes or surfaces."

could this be the case? have you checked the available components on the panel3d tab/group? Maybe their behavior has changed (or it's just a bug which you could post on the PT group)

Permalink Reply by Nancy Yen-wen Cheng on February 17, 2017 at 11:30am

I also had inconsistent results with 3D Morph List. It works with my variable spin gizmo, but not when I tried creating a very simple example for my students. :(

Attachments:

spin-morph3d-add.gh, 29 KB
spin-morph3d-add.3dm, 258 KB

Permalink Reply by John Stack Ross on February 17, 2017 at 9:46pm

Nancy,

Could be a couple of things

1) The way you're organizing the POs and the BOs.

2) Looks like you're grafting the input data for the POs? Make sure that is done...but again, if you input a series through one Brep component it may confuse the list.

I'm attaching a very simple GH screen capture. I'm not using BOs in the example, but I would think it should follow the same input process as the POs.

Hope this helps.

Best,

John

Attachments: