Paneling tools help!

Hi i was finding it difficult to apply two different surfaces on for a morph3d surface using paneling tools. I'm quite new to grasshopper so it would be great if anyone have any suggestions. I have attached my file and script. Thanks

Attachments:

script.rar, 60 KB

Replies to This Discussion

Permalink Reply by Kelvin on April 10, 2013 at 7:08pm

Maybe I wasn't that clear, I'm trying to get the patern(mesh) to attach onto the inner surface but will it work if the srf outside is wavy and the geometry inside is rigid? Because with paneling tools you need one srf that is offset in order to get the point of origin and the offset point to create the pattern that you attach.

Permalink Reply by djordje on April 11, 2013 at 5:18am

Hi Kelvin,

The Ning forum (this one) has some issues when .rar files are attached. Try attaching the .zip file instead or directly .gh/.3dm.

Permalink Reply by Kelvin on April 11, 2013 at 9:26am

Hi, i've attached the file as a zip file. Hope it works this time. Thanks for the reply. Hope to hear from you soon!

Attachments:

script.zip, 63 KB

Permalink Reply by djordje on April 11, 2013 at 10:13am

Sorry I could not open your .3dm file as it it version 5.
Apart from that I just realized you were using the Paneling tools components inside of your .gh file, which I do not have installed and never used.

RSS