Grasshopper

algorithmic modeling for Rhino

Hi everyone, I am working with a project where I use Grasshopper for modelling a tunnel, a complicated one. This means ofcourse that I have used a lot of parameters and components.

Now I get some "out of memory" on nearly every kind of components. How did you guys who had similiar problems, solve or increased "the memory"?

Views: 578

Replies to This Discussion

Keep a close eye on the output of all your components.  A mistaken graft here or there can produce shocking numbers of geometry, several  orders of magnitude more than expected.

I am actually divided the whole tunnel into some sections, but I am very careful with the number of points and all the outputs. Still it will be very hard to go through every component. I got this message first, and now I replaced all the merge with Weave and the Simplify tree with "right click" and choose Simplify +Flatten

But today I got the same problem again but this time is about the component Multiplication

Attachments:

Well, its basically an error message I got, I dont know so much about it, but its message saying this:

then by choosing OK, I get an other message about "Grasshopper Display error" and clicking on OK on that one too, then the Grasshopper interface or Canvas gets red.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service