Grasshopper

algorithmic modeling for Rhino

orthographic lines

Dear All,

I was wondering whether it is possible to have line segments on a plane that can be formed only in a certain orientation? I'm trying to create some lines that can only be created which are in angles of 45 degrees (sort of like the Ortho function in Rhino). Can this be achieved in Grasshopper?
Any help would be much appreciated!

Thanks,

Ben

Views: 368

Replies to This Discussion

Permalink Reply by David Rutten on November 16, 2009 at 3:53am
Hi Ben,

have you got a picture to go along with that?

--
David Rutten
david@mcneel.com
Poprad, Slovakia
Permalink Reply by Ben Lee on November 16, 2009 at 3:57pm
Hi David,

Something like this (see attached image) - what I want to do is to have the lines generated between a grid of points to 'travel' only in 45 degree increments....ideally if between 2 points, a line cannot be generated oriented in 45 degrees then it could be rebuilt so that it 'zigzags' in 90 degree segments between them.

Thanks

Ben
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service