Grasshopper

algorithmic modeling for Rhino

orienting direction

Hi 
I am building this proliferation of components the components are basicly identical, but have the ability to change the curvature, each component individualy.
I tried making the proliferation with "orient direction" but there seems to be a problem beacause the component moves its orientation not only when the directing vector and point change but also when the very component itself moves.
Well, its kind of hard explaining it, I hope the script will make it easier to understand. Though it is also quite complicated.
If you think you can help me, It is realy urgent for a presentation I have in a few days

Thanks 
Yaron

Views: 288

Attachments:

Replies to This Discussion

Permalink Reply by Jacek Jaskólski on October 28, 2010 at 1:30pm
hi yaron,

I looked into your definition and yes, it's quite complicated - could you maybe post an image explaining which geometry is "the component" and express what exactly is the problem?
Permalink Reply by yaron israel on October 29, 2010 at 2:39pm
Hi
I hope this cleares it up a bit. the components are the arcs (with the pipes revolving them)
Thanks
Yaron
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service