Orient to curve not to origin

Replies to This Discussion

Permalink Reply by Ethan Gross on September 6, 2015 at 10:40pm

Hi Pablo, not sure if this is what you're looking for...

Attachments:

• 2d_scaledfromcenter_orient_perp.gh, 21 KB

Permalink Reply by Pablo on September 7, 2015 at 1:08am

Thank you so much Ethan Gross,

You have helped me tremendously. I actually intended to rotate the circles parallel to the curve, However I have already done so after your help in changing the orientation to its perpendicular as i had incorrectly asked for.

-Pablo

Attachments:

• Grasshopper_help-01.5.jpg, 391 KB
• 2d_scaledfromcenter_orient_parallel.gh, 29 KB